Back to all reports

Inadequate Re-Surfacing to the Cycle Path

Reported in the General Highways Enquiry category by James Farnfield at 11:40, Monday 20 May 2019

Sent to Bristol City Council 5 minutes later

The re-surfacing work recently carried out on the cycle path has the following issues, 1. Raised by at least 2-3cm from the original surface 2. The surface is not level and is causing a very bumpy ride 3. Asphalt used is of lower quality then the original construction and will be less durable, this can be seen where previous re-surfacing (between Morrisons and the Former Staple Hill Railway Station) has been completed and is degrading whereas the original surface is fine. Has a quality check of the work been completed before it was signed off / approved? Would the defects of this re-surfacing work be acceptable on a highway or pavement?

This query is applicable to all the recent replacement surface work done between Morrisons, Clay Bottom, Upper Easton, Lawrence Hill and City Centre.

RSS feed of updates to this problem Receive email when updates are left on this problem.

Updates

  • Enquiry raised.

    Posted by Bristol City Council at 10:45, Monday 20 May 2019

  • Under investigation.

    Posted by Bristol City Council at 11:21, Monday 20 May 2019

  • Your enquiry has been passed to the appropriate department. We will only contact you should we need more information.

    State changed to: Fixed

    Posted by Bristol City Council at 12:32, Monday 20 May 2019

This report is now closed to updates. You can make a new report in the same location. Please reference 1634806 in your new report if it is an update on this one.